 |
 |
 |
 |
 |
 |
 |
|
| Q.No.4419: | When using Nikon Capture 3 Camera Control over an IEEE 1394 connection and other IEEE 1394 devices connected to the same computer are turned off, the message asking to quit Camera Control is displayed and then Camera Control quits. |
| Ans : | This phenomenon occurs because when one or more of several IEEE 1394 devices connected to a single computer are turned off, the bus is reset.
Since there is no way to correct or compensate for this at the present, please refrain from turning additional IEEE 1394 devices on or off while using Nikon Capture Camera Control. |