| Q.No.4122: |
With the D100 connected to a Macintosh computer running Mac OS 9 or Mac OS X, I can transfer images,
but I cannot use the Camera Control function. Similarly, I can use the Camera Control function,
but I cannot transfer images. |
| Ans : |
Please verify the following:
|
| 1. |
To use Nikon Capture 3 Camera Control on a Macintosh computer, the D100 firmware must be
version 2.00. If your camera's firmware is an earlier version, please upgrade to firmware version 2.00.
|
| 2. |
To use Nikon Capture 3 Camera Control on a Macintosh computer, Nikon Capture 3 version 3.5.0
or later is required. If you are using an earlier version of Nikon Capture 3, please upgrade to Nikon Capture 3
version 3.5.0 or later.
|
| 3. |
Verify your camera's USB setting from the SETUP menu.
When the D100 is used with Mac OS 9, Nikon Capture 3 Camera Control requests that you set the USB transfer
protocol to "PTP".
When transferring images using Nikon Transfer, however, you must set the USB transfer protocol to "Mass Storage".
|
| * |
Under Mac OS X, images may be transferred using either USB setting.
|
