 |
 |
 |
 |
 |
 |
 |
|
| Q.No.1204: | When I use Nikon Capture over an IEEE 1394 connection, the program doesn't recognize the D1 (Windows). |
| Ans ¥ | Are you using a Nikon-approved IEEE 1394 interface board? |
| ¥ | Is the IEEE 1394 interface board correctly installed?
(For details, consult the documentation provided with the interface board.) |
| ¥ | Is the camera battery correctly installed?
Is the battery exhausted? (Use a fully charged battery.) |
| ¥ | If you are using the AC adapter, is it properly connected? |
| ¥ | Is the camera on? |
| ¥ | Is the camera in sleep mode?
(Half-press the shutter-release button to wake the camera up.) |
| ¥ | Is the camera in "Pc" mode? |
| ¥ | Are the camera and computer correctly connected? |
| ¥ | Apart from the camera, are any other IEEE 1394 peripherals connected to the computer?
(Disconnect from the computer all IEEE 1394 devices other than the camera and use the camera by itself.) |
| ¥ | Re-install Nikon Capture after first uninstalling it. |
| ¥ | Is the IEEE 1394 cable less than 4.5 m in length? |